Si-tex CVS-126 Manual de Instruções Página 6
- Página / 61
- Índice
- MARCADORES
Avaliado. / 5. Com base em avaliações de clientes
Contents CVS-126
vi 0093132702-01
Stopping the alarm sound ..........2-5
Setting the alarm ........................2-6
Release the alarm. .....................2-6
Confirm the alarm state..............2-6
2.13 Preset/ WPT edit/ WPT delete of
Destination.................................2-6
NAV Start....................................2-6
Cancel the NAV. .........................2-7
Edit the destination.....................2-7
Delete the destination. ...............2-8
Recall the image stored and
preset it as a destination. ...........2-8
2.14 Store/Recall/Deletion of Image...2-9
Store the image. .........................2-9
Recall the stored image. ............2-9
Delete the stored image. ............2-9
Add the comment to the stored
image........................................2-10
2.15 Selection of Zoom ....................2-10
2.16 Selection of NAV Display ......... 2-11
Type of NAV Display................. 2-11
Dividing Method of Display....... 2-11
Selection of NAV Menu ............ 2-11
2.17 Explanation of Sonar................2-12
Switch-over of Sonar Tone .......2-12
Connection of External
Speaker ....................................2-12
2.18 Explanation of Menu Item ........2-12
TVG ..........................................2-12
Change the TX power. .............2-12
Display the A scope. / Stop the
display of A scope. ...................2-13
Change the display color of echo
sounder image..........................2-13
Change the depth value. ..........2-13
Display the water temp graph. /
Stop the display of water temp
graph. .......................................2-13
Disp Width................................2-13
Image Swap .............................2-14
Chapter 3 How to use the system menu .3-1
3.1 Display of System Menu ............3-1
3.2 Setting of External In/Out ...........3-1
3.3 Setting of Correct Item ...............3-2
3.4 Setting of System Item ...............3-2
3.5 Setting of Basic Set Item............3-3
3.6 Maintenance Menu.....................3-3
Chapter 4 Maintenance and Inspection...4-1
4.1 Inspection ...................................4-1
4.2 Cleaning .....................................4-1
4.3 Fuse Replacement .....................4-1
4.4 If you suspect a trouble ..............4-2
4.5 Diagnostic Test...........................4-3
Chapter 5 Installation ..............................5-1
5.1 Item of Caution on Installation.... 5-1
5.2 Installation of CVS-126 Display
unit ..................................................5-2
5.3 Installation of Transducer ........... 5-5
5.4 Wiring .........................................5-7
5.5 Serial Data................................5-10
Chapter 6 Table Attached........................6-1
6.1 Menu List....................................6-1
6.2 Specification ...............................6-3
6.3 Appearance ................................6-4
- Important Notice 2
- For Your Safe Operation 3
- Caution Item on Equipment 4
- Contents 5
- Introduction 7
- System Configuration 8
- Configuration of Equipment 10
- Essential Option 11
- Type of transducer 11
- Option List 11
- Chapter 1 Basic Operation 12
- 1.2 Power On/Off 14
- Low frequency(50kHz) 15
- High frequency(200kHz) 15
- Dual Frequency 16
- (1) Bottom 17
- (2) Bottom Discrimination 17
- (3) Zoom 17
- Navigation Menu (NAV1, NAV2) 18
- The range value 19
- changes 19
- 1.7 Use of 【EVENT】 key 21
- 1.8 Use of 【FUNC】 key 23
- 1.9 Operation of VRM 24
- 2.1 How to operate the 25
- Image of school of fish 26
- Interference image 26
- Noise Rejection 27
- Color Rejection 27
- Switch-over of Menu 28
- ～800,ft:0～2800) 29
- 2.132.13 30
- 2.13 Preset/ WPT edit/ WPT 30
- (See [1.7 32
- Destination is delete 32
- 2.142.14 33
- 2.14 Store/Recall/Deletion 33
- 2.152.15 34
- 2.15 Selection of Zoom 34
- 2.162.16 35
- 2.16 Selection of NAV 35
- Display 35
- Sonar tone 36
- Image Swap 38
- (See [1.8 41
- (See [1.2 41
- Initialize 42
- System Check 42
- All WPTs deletes 42
- All stored image deletes 42
- CVS-126 Display unit 43
- Transducer 43
- 4.5 Diagnostic Test 45
- Chapter 5 Installation 46
- Desk-top Installation 48
- Flush-mount Installation 48
- In case of Inner-Hull 50
- In case of through hull 51
- 5.4 Wiring 52
- To [POWER] connector 53
- 3.5 stereo jack 53
- DC+ (Red) 53
- DC- (Black) 53
- To [TD] connector 53
- 5.5 Serial Data 55
- Chapter 6 Table Attached 56
- 0093132702-01 6-2 57
- 6.2 Specification 58
- 6.3 Appearance 59
- 6-5 0093132702-01 60
© 2020, manymanuals-pt.com. Todos os direitos reservados. | 0.058 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Comentários a estes Manuais